Справочник Пользователя для Mitel 2700-1398-B1

Mitel NuPoint Messenger Technical Documentation - Release 7.0

 

class of Service (FCOS). The server accepts any FCOS number from 1 through 640, even if 
no feature bits are programmed for that FCOS. No error message is issued. Be sure to enter 
the correct Feature Class of Service! 

• 

When Administration by Phone prompts for a three-digit limits class of service, enter the 
Limits Class of Service (LCOS). The server accepts any LCOS number from 1 through 640. 
Be sure that you enter the correct LCOS. 

• 

You can assign any valid message waiting indication to the mailbox, but you cannot add 
other information by phone, such as paging. This message waiting indication does not work 
without extra programming. You can create mailboxes that require extra programming at the 
server maintenance console. 

The single exception to this rule is the AC message lamp. The following section gives instructions 
for programming an AC message lamp address by telephone. 

An AC message lamp address consists of a House Code, which can be any letter from A 
through P, followed by a Unit Code, which can be any number from 1 through 16. Examples are 
A1, D5, P16. Address P1 is reserved for troubleshooting and diagnostics and cannot be assigned 
to a mailbox. Due to the limitations of the telephone key pad, you must enter the address 
differently. 

1.  House Code: Numbers 2 through 9 on your telephone key pad represent three different 

letters each. In order to specify which letter is desired, the server requires that you enter two 
numbers to represent a house code letter: the key number, then the letter position (from the 
left). For example, you enter K as 52, because K is on the number 5 key and at the second 
position from the left (JKL). Table 9-1 lists the AC message lamps house codes. 

A 21 I  43 

B 22 J  51 

C 23 K 52 

D 31 L  53 

E 32 M 61 

F 33 

N 62 

G 41 O 63 

H 42 P 71 

 

2.  Unit Code: Since the server prompts for a four-digit AC message lamp address, you must 

enter Unit Codes as a two-digit number. For example, numbers from 1 through 9 are entered 
as 01 through 09. 

Note:  If you want to verify that the AC message lamp address was entered correctly, press M to modify the 

mailbox you have just added, and press the star (*) key in response to each prompt to leave all 
values unchanged. The server gives the current AC message waiting lamp address as “K1” (not 
5201). 

You can delete a single mailbox, but not a range of mailboxes by phone. 

133