Справочник Пользователя для Pelco PMC14EX

Pelco Manual C929M-B (2/97)

5

Refer to Table A for the type of video coaxial cable to use.

Refer to Figure 1 for rear panel connections.

Connect equipment to the monitor as follows. There are several options for inputs 1
and 2 as shown on this and the following pages. Select the appropriate one.

Figure 2.  Camera Inputs

CAMERA ONE

CAMERA TWO

SET FOR 75 OHMS

AC INPUT

INPUT

INPUT

OUTPUT

OUTPUT

VIDEO

AUDIO

INPUT 1

INPUT 2

VIDEO 2

AUDIO

OUTPUT

VIDEO

AUDIO

VIDEO

AUDIO

IN

OUT

75 ohm

HIGH

  Do not install

this monitor in an exces-
sively hot location, or in any
way obstruct the ventilation
openings in the cabinet. Pre-
mature component failure or
damage to the cabinet may
result.

 Table A. Video Coaxial Cable Wiring Distances

Cable Type

Maximum Distance

RG59

         750 ft (229 m)

RG6

      1,000 ft (305 m)

RG11

      1,500 ft (457 m )

 Do not connect equipment

to both the BNC and Y/C connec-
tors on the same input. If the moni-
tor senses a signal at both connec-
tors, the Y/C input will be selected.

1.

Refer to Figure 2. Connect cameras and audio equipment to the inputs 1 and/
or 2. Note that each input has two video connectors: a BNC connector for a
standard composite video signal and a four-pin jack for a Y/C signal input. The
Y/C input provides luminance (Y) and chrominance (C) signal input from Su-
per VHS equipment.

2.

Set the 75-ohm/HIGH switch for 75 ohms if you are using Input 1.