Справочник Пользователя для Pelco HS5001
Pelco Manual C489M-A (1/96)
3
4.0 INSTALLATION
Before installing the HS5000/HS5001, make certain that
the mounting surface is able to support the full load of
the enclosure plus all other equipment such as camera,
lens, etc.
the mounting surface is able to support the full load of
the enclosure plus all other equipment such as camera,
lens, etc.
NOTE: The fasteners required to secure the
enclosure to a mounting surface are not sup-
plied.
enclosure to a mounting surface are not sup-
plied.
4.1 HS5000 WIPER/WASHER/HEATER
CONNECTION
The wiper/washer/heater units are factory pre-wired for
12 VDC operation and only require a 12 VDC supply
(5 amp minimum) be connected to the red positive (+)
and black negative (-) leads provided at the rear of the
enclosure through the conduit hole.
12 VDC operation and only require a 12 VDC supply
(5 amp minimum) be connected to the red positive (+)
and black negative (-) leads provided at the rear of the
enclosure through the conduit hole.
A section of fluid tubing exits the enclosure also (1/8"
I.D. x 1/4" O.D. vinyl). This tube must be connected to
a supply of water and/or cleaning solution (which must
be compatible with GE Lexan with Margard).
I.D. x 1/4" O.D. vinyl). This tube must be connected to
a supply of water and/or cleaning solution (which must
be compatible with GE Lexan with Margard).
Refer to Figure 1 for proper connections.
4.2 HS5001 HEATER CONNECTION
Heater connections for all models used with the HS5001
are wired the same. Refer to Figure 2 for proper wiring
connections.
are wired the same. Refer to Figure 2 for proper wiring
connections.
The heaters are all thermostatically controlled. They
are activated ON at 40
are activated ON at 40
°F (4.44°C) and are activated
OFF at 60
°F (15.56°C).
1
2
3
4
5
6
7
8
9
2
3
4
5
6
7
8
9
10
Figure 2. Wiring Diagram for HS5001 Heaters
HEATER
Figure 1. HS5000 Wiper/Washer/Heater Connections
INPUT, AC HIGH
INPUT, AC LOW (NEUTRAL)
GROUND
INPUT, AC LOW (NEUTRAL)
GROUND