Справочник Пользователя для Pelco MPS524DT/220

Pelco Manual C545M-E (2/02)

5

The following items are supplied:

•

MPS5DT, MPS524DT, or MPS524DT/220

•

6-pin mating connector with pins

•

2 screws

The first thing you must do is assemble the mating connector. The following steps apply to
all AMP style connectors regardless of pin size or pin number. Refer to Figure 1 during as-
sembly.

1.

Slide the connector clamp assembly over the conductor cable.

2.

Determine the size of wire to use. Refer to the 

Specifications

 section.

3.

Prepare the wires from the conductor cable as follows:

a.

Strip at least 1" from the cable jacket to expose the wires. You may need to strip
more from the cable jacket if you have more wires.

b.

Strip 1/8" from each wire.

c.

Using an AMP-style crimper, crimp the wires and their insulation to the connector
pins. Refer to Detail A in Figure 1.

4.

Slide the connector pins into the appropriate holes in the connector body until they
snap into place. You can see the pin assignments in Table A.

Table A. PIN Assignments

1

Common/AC Low

2

Right

3

Left

4

Auto

5

120 VAC HI for PS20 scanner and camera power or
24 VAC HI for PS20-24 scanner and camera power

8

Chassis Ground

5.

Push the connector clamp assembly towards the connector body and screw it onto the
connector body. Be careful not to disturb the wires.

6.

Attach the appropriate clamp with the screws provided and tighten.

OR

00103

1"

1/8"

FRONT VIEW

1

3

4

7

8

11

12

14

Figure 1.  Connector Assembly

 Pin 5 is not used

with  PS7 and PS30 Series
Scanners.