Справочник Пользователя для Pelco HS2500
PELCO Manual C486M-B (9/95)
1
Please thoroughly familiarize yourself with the information in this manual
prior to installation and operation.
This symbol indicates that there are important
operating and maintenance instructions in the
operating and maintenance instructions in the
literature accompanying this unit.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present
constituting a risk of electric shock is present
within this unit.
CAUTION:
TO REDUCE THE RISK OF ELECTRICAL
SHOCK, DO NOT REMOVE COVER. NO
USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
SHOCK, DO NOT REMOVE COVER. NO
USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The product bears the following marks:
1.0 WARNINGS
Prior to installation and use of this product, the following
WARNINGS should be observed.
WARNINGS should be observed.
1.
Installation and servicing should only be done by
Qualified Service Personnel and conform to all
Local codes.
Qualified Service Personnel and conform to all
Local codes.
2.
Unless the unit is specifically marked as a NEMA
Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is
designed for indoor use only and it must not be
installed where exposed to rain and moisture.
Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is
designed for indoor use only and it must not be
installed where exposed to rain and moisture.
3.
The weight of the camera/lens and enclosure shall
not exceed 20 lbs (9.07 kg) — subject to specific
pan/tilt unit.
not exceed 20 lbs (9.07 kg) — subject to specific
pan/tilt unit.
INSTALLATION/OPERATION MANUAL
MODEL HS2500 HIGH SECURITY
CAMERA ENCLOSURE
MODEL HS2500 HIGH SECURITY
CAMERA ENCLOSURE
4.
Only use replacement parts recommended by
PELCO.
PELCO.
5.
After replacement/repair of this unit’s electrical
components, conduct a resistance measurement
between line and exposed parts to verify the exposed
parts have not been connected to line circuitry.
components, conduct a resistance measurement
between line and exposed parts to verify the exposed
parts have not been connected to line circuitry.
6.
The installation method and materials should be
capable of supporting four (4) times the weight of
the enclosure, pan/tilt, camera and lens combination.
capable of supporting four (4) times the weight of
the enclosure, pan/tilt, camera and lens combination.