Справочник Пользователя для Pelco HS2500

2

PELCO Manual C486M-B (9/95)

The information within this manual covers the installa-
tion of the HS2500 High Security Camera Enclosure.

The HS2500 is a high security camera enclosure de-
signed for indoor use in applications such as elevators,
parking garages, stairwells, detention cells or other ar-
eas requiring maximum protection from vandalism. The
HS2500 fits flush to the ceiling in a corner, but can be
mounted lower on the wall and still retain it’s effective-
ness. The enclosure is supplied with an impact-resis-
tant clear Lexan window. Options include a smoked
window, thermostatically controlled heater kit (120
VAC/24 VAC) and 3-1/2" (8.89 cm) square, 12 watt, 8
ohm speaker for optional audio surveillance.

Constructed of medium gauge steel, the HS2500 will
accept many of the smaller CCD cameras with fixed
focal length lenses and auto-iris lenses. There is no ex-
posed mounting hardware securing the HS2500 to its
mounting surface. Opening the enclosure can only be
accomplished by removing the tamper-resistant screws
from the bottom and lifting the hinged cover.

Before installing the HS2500 to a wall, make certain
that the mounting surface is able to support the full
weight of the enclosure plus the camera and lens.

The tilt table and tilt table mounting brackets may be
removed to provide adequate clearance for mounting
the enclosure.

NOTE: The six (6) fasteners required to se-
cure the HS2500 to a wall (minimum 3/8"
(.95 cm) diameter recommended) are not sup-
plied.

To mount the enclosure to a wall, follow the steps out-
lined below.

1.

Open the enclosure by unscrewing the two tampruf
screws at the bottom and lifting the cover. A special
socket tool is provided (fits 1/4" square drive).

2.

Using the mounting bracket as a template, mark
and drill holes in the mounting surface.

3.

Attach the enclosure with the required fasteners.

4.

Route the required cables through the back.

5.

If you have purchased the optional smoked win-
dow and/or heater kit, proceed to Sections 4.2 and/
or 4.3.

6.

Mount the camera/lens to the tilt table according
to the instructions in Section 4.4.

The HS2500 is provided with a clear Lexan 1/4" (.63
cm) thick viewing window. An optional smoked win-
dow is available.

Instructions for installing the optional smoked window
are as follows:

1.

Open the enclosure by unscrewing the two tampruf
screws at the bottom and lifting the cover.

2.

Remove the four (4) 1/4-20 elastic locknuts and 1/4"
flat washers retaining the window.

3.

Remove the window.

4.

Remove the protective coatings from the new win-
dow and place the window over the four (4) 1/4-20
studs.

5.

Replace the hardware and close the cover.