Справочник Пользователя для Pelco C2410M-1

 

C2410M-I  (1/06)

9

 

Place the trim ring and dome over the back box. If the 
dome has a liner, position the viewing window over 
the lens of the camera. Tighten the tamper-resistant 
screws with the supplied 1/8-inch hollow screwdriver 
bit. Note that the screws are installed at an angle.

 

If you have a color camera, it is set up at the factory and normally requires no adjustments. 
Sometimes, however, adjustments may be necessary.

1. Remove the dome and trim ring using the supplied 1/8-inch hollow screwdriver bit.

2. Adjust the vertical phase, iris level, focus, or switch settings (refer to procedures below).

3. Replace the dome and trim ring.

 

Adjustment is required if there is vertical roll when switching between two cameras.

1. Reverse the 24 VAC connections on one camera. If both cameras are connected to the same 

transformer, this should solve the problem.  

2. If reversing the connections does not solve the problem, or if cameras are connected to 

different transformers, turn the adjustment screw on one camera (while switching as rapidly 
as possible between the two camera views) until the switching is clean and there is no 
vertical roll. If more than two cameras are out of synchronization with each other, choose one 
camera and synchronize all others to it.

VERTICAL
PHASE
ADJUSTMENT

VERTICAL PHASE
ADJUSTMENT