Справочник Пользователя для Pelco C3432M-F

C3432M-F (6/08)

13

1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from 

the back box.

2. Remove the conduit plug from the cover. Install a 0.75-inch (1.91 cm) threaded conduit connector 

(not supplied) into the conduit hole in the cover.

3. Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware 

when installing the system outdoors.

4. Install the camera module into the back box before installing the back box into the cover. Rotate the 

camera module to access the mounting holes inside the back box. Refer to Camera Module on 
page 19 for more information.

5. Connect the cable/wires (refer to Wiring Tables on page 14 for information).

6. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and 

washers (removed earlier) to secure the back box to the cover.

Figure 8. Side Conduit Installation

COVER

BACK BOX

8-32 X 0.375-INCH

PHILLIPS PAN HEAD

SCREWS WITH WASHERS

(SUPPLIED)

0.75-INCH CONDUIT

CONNECTOR

REMOVE

CONDUIT PLUG