Справочник Пользователя для Allstar Products Group AC9300

CONTROL AND AUXILIARY EQUIPMENT

INSTALLATION OF A STANDARD WALL PUSH BUTTON OR DELUXE WALL STATION CONTROL

A standard wall push button is included

in your hardware package, an optional

Deluxe Wall Station may be purchased

from your installing dealer. The operat-

ing parameters for the standard wall

push button and the Deluxe Wall Station

are outlined on pages that follow

(“Operating Instructions”) to see what

mode of operation is right for you. All-

star recommends the Deluxe Wall Sta-

tion installation, as it will provide full

control over the garage door operator and its functions at all times. You may install one Deluxe Wall Station and one or more stan-

dard push buttons to a Challenger AC9000 Series operator following the cautions and instructions outlined below.

STEP 1:

After determining a suitable location, usually near the access door and at least 5 feet above the floor to prevent use by

children, use the standard wall push button or Deluxe Wall Station as a guide to mark the mounting holes. Drill holes for drywall

anchors or screws. NOTE: Do not mount directly to masonry walls. Use backer board.

STEP 2:

A length of 2-conductor, #22 gauge wire (or heavier) is required to connect the control button to the garage door operator.

Strip approximately 2” of the wire jacket from one end and 1/2” of insulation from each wire. Carefully connect one wire to each of

the two terminals. Carefully tuck the loose wires into the case and mount the unit using appropriate screws.

STEP 3:

Run the wire from the control button to the operator, supporting it at 18” intervals with suitable staples. Leave a

sufficient length to make the necessary connections to the operator terminal strip.

WARNING: SOME LOCAL BUILDING CODES DO NOT ALLOW

SURFACE WIRING. BE SAFE AND CHECK WITH YOUR LOCAL

BUILDING INSPECTOR FIRST.

STEP 4:

Ensure power is OFF to the operator or disconnect the power from the

operator. Strip approximately 4” of jacket from the end of the wire and 1/2”

insulation from each wire. Connect to terminals 0 and 1 as shown in the

illustration. Support the wire near the operator with wire ties.

Step 5:

Install the

Co ntr ol B utto n

W ar ni n g L ab el

supplied with your

Challenger AC9000

Series operator near

the control button

(see illustration).

Repeat the Steps 1

thru 5 above to in-

stall additional stan-

dard wall push but-

tons if desired.

Every control must

have a separate Con-

trol Button Warning

Label mounted near it. Contact the factory for additional labels if

needed.

WARNING

A CHILD OPERATING THE DOOR CONTROLS

RISKS INJURY — OR DEATH — TO HIMSELF AND

OTHERS. DO NOT ALLOW CHILDREN TO

OPERATE

ANY

DOOR CONTROLS.

MOUNT THE PUSHBUTTON AT LEAST 5 FT FROM

THE FLOOR, OUT OF REACH OF CHILDREN.

!!!!

Child can be pinned under automatic garage
door. Death or serious injury can result.

• Never let child walk or run under moving door.

• Never let child use door opener controls.

• Always keep moving door in sight.

• If person is pinned, push control button or use

emergency release.

• Test door opener monthly:

Refer to your owner’s manual

Place one-inch object (or 2x4 laid flat) on floor.

If door fails to reverse on contact, adjust opener.

If opener still fails to reverse door, repair or replace opener.

WAR N I N G

104350

CONTROL BUTTON WARNING LABEL

WARNING

IMPROPER DOOR OPERATION COULD

CAUSE INJURY OR DEATH. WARNING

LABEL MUST BE MOUNTED ON WALL NEAR

THE PUSHBUTTON. ALL WARNINGS AND

INSTRUCTIONS ON THE LABEL SHOULD BE

STRICTLY ADHERED TO.

109986