Справочник Пользователя для Allstar Products Group AC9300

WARNING

SPRINGS, PULLEYS, CABLES AND MOUNTING HARDWARE USED TO BALANCE YOUR

GARAGE DOOR ARE UNDER EXTREME TENSION AT ALL TIMES AND CAN CAUSE SEVERE

INJURY OR DEATH IF DISTURBED. DO NOT ATTEMPT ADJUSTMENT.

IMPORTANT!

IDENTIFY YOUR DOOR TYPE FROM THOSE ILLUSTRATED BELOW AND FOLLOW

INSTRUCTIONS FOR THAT TYPE OF DOOR

INSTALLING THE OPERATOR

SECTIONAL DOOR
CURVED TRACK

ONE PIECE DOOR
HORIZONTAL TRACK
JAMB HARDWARE

HIGH ARC OF
DOOR TRAVEL

TRACK

DOOR

FOR THESE TYPES OF DOORS USE 1/3 HP

MODEL AC9300 OR 1/2 HP MODEL AC9500.

USE 7 FT, 8 FT OR 10 FT RAIL ASSEMBLY

(MATCH DOOR HEIGHT)

104367

ONE PIECE DOOR
NO TRACK
JAMB HARDWARE

ONE PIECE DOOR
NO TRACK
PIVOT HARDWARE

DOOR

HIGH ARC OF
DOOR TRAVEL

DOOR

JAMB

HARD-

WARE

HIGH ARC OF

DOOR TRAVEL

PIVOT

FOR THESE TYPES OF DOORS USE

1/2 HP MODEL ACJ9500.

USE 7J RAIL

(FOR DOOR HEIGHT UP TO 8 FT)

104368

REINFORCE THE HEADER WALL

Reinforce the header wall (wall above the door opening as required,
to ensure rigid mounting of the front wall bracket.

Locate the vertical centerline of your garage door and mark it on the
header above the door and on the top rail of the door.

Vertical Center

Line

Reinforce with 2” x 6”

as required to insure

rigid mounting.

110048

STEP 1:

Mounting the Front Bracket — Sectional Doors and One-

Piece Doors with Track (For One-Piece Doors without track see Step 1A,
next): Mark a vertical centerline on the header above the door. By
manually raising the door, determine the high arc of the door’s travel (see
illustration, top of previous page) and using a level, transfer this
measurement to the header (see illustration at left). Draw a horizontal line,
crossing the previously drawn centerline, at this point. Install the Front
Mounting Bracket securely wit lag screws as shown below. If necessary,
reinforce the header with steel angle iron or wood to ensure a secure
mount.

HORIZONTAL
LINE

104369

VERTICAL
CENTERLINE