Справочник Пользователя для Vermont Casting DV360

40

To convert the DV360/580 units for use with a different 
gas follow these instructions. Before proceeding, turn 
control knob on valve to “OFF” and turn gas supply 
OFF. Turn OFF any electricity that may be going to the 
appliance.
CAUTION: Logs may be HOT! Allow to cool before 
proceeding.
1.  Open louvre assembly bottom to gain access to 

valve. Remove window frame assembly. (See “Win-
dow Frame Assembly Removal”, Page 24, Fig. 47)

2.  Remove logs if previously installed.
Honeywell Valve
1.  Remove cap from HI/LO knob. This can be accom-

plished by lifting the plastic cap off the screw. (Fig. 
63)

2.  Remove the screw from center of HI/LO knob with 

small screwdriver turning counterclockwise. (Fig. 63)

3.  Insert conversion screw supplied in conversion kit. 

Blue for natural gas, red for LP.

4.  Tighten screw, replace cap.

CO100

Gas conversion

HI-LO knob

3/15/99   djt

Cap

Lift Open

Hi/Lo 

Knob

Remove Center Screw

CO100

Fig. 63  Remove center screw from Hi/Lo knob.

NOVA SIT820 Valve
1.  Using the TORX T20 bit, remove and  discard the 

three (3) pressure regulator mounting screws (A), 
pressure regulator tower (B) and the spring and 
diaphragm assembly (C).  (Fig. 64)

FC107

SIT820

valve conversion

10/03   

A

B

C

OFF

PILO

T

ON

FC107

Fig. 64  Remove mounting screws, pressure regulator tower 
and spring and diaphragm assembly.

2.  Insure the rubber gasket (D) is properly positioned 

and install the new HI/LO pressure regulator assem-
bly to the valve using the new screws (E) supplied 
with the kit. Tighten the screws securely. (Ref. torque 
= 25 in/lb) (Fig. 65)

3.  Install the enclosed conversion label (F) to the valve 

body where it can easily be seen. (Fig. 65)

Valve conversion is complete.

D

E

F

FC108

SIT

regulator

conversion

10/03

OFF

PILOT

ON

FC108

Fig. 65  Replace regulator.

1.  Remove the screws that secure the fettle and the 

burner tube assembly, located behind the burner 
tube assembly. Remove the four (4) screws that se-
cure the burner housing assembly to the base pan at 
the right and left end of the burner housing assem-
bly. (Fig. 66)

�����
������������
���������

Burner Housing 

Assembly

Pilot Location

Remove 

Screws

Burner Tube 

Assembly

Remove Screws

CO129

Fig. 66  Remove screws holding burner housing assembly 
and burner tube assembly.

2.  Remove the fettle and the burner tube assembly. 

Slide the burner housing assembly to the right and 
up to free the orifice.