Справочник Пользователя для Majestic Appliances 33LDVR

35

This auxiliary fan system increases the efficiency of the 

circulation of the heated air.
The FK24 fan kit allows variable speed control of the 

circulation fan and also incorporates a heat sensor in 

the circuit.
Specifications
115 Volt / 60Hz / 56 Watts 
Maintenance
The fan itself does not require regular maintenance, 

however periodic cleaning of the fan and the 

surrounding area is required.
Check the area under the control door (lower louvre 

assembly) and in front of the fan and wipe or vacuum 

this area at least once a month during the operating 

season.
Installation
The fan assembly and other components are supplied 

fully wired, eliminating the need for a licensed 

electrician to carry out the installation.
If hard wiring the fan using Method B (following) we 

strongly recommend the use of a licensed electrician.
1.  Open the lower louvre assembly. Move the fan & 

bracket assembly around the gas valve and lines to 

locate the unit onto the screw studs on the back of 

the fireplace.

2.  Install the thermal sensor under the bottom of the of 

the firebox, locating it over the two 10mm studs and 

secure it with nuts.

3.  Locate the fan speed control unit. This can be fitted 

behind the lower louvre assembly as in Figure 54 

or located remotely in a conveniently located wall 

mounted electrical box. Remote location of the 

speed control will require suitable extension of the 

component wiring.

4.  The power supply may be connected in two ways:

  Route the 6ʼ lead fitted to the unit to a conveniently 

located wall socket.

  Method B (Using EB-1 Receptacle Box)

  The EB-1 receptacle box (Pt. # ZA1200) may be 

hard wired into the house supply. The fan lead is 

then plugged into the EB-1 box. For instruction 

on wiring the EB-1 receptacle box see the earlier 

chapter in the Installation section of this manual.

FK12
This auxiliary fan system increases the efficiency of the 

circulation of the heating air. 
The FK12 Fan Assembly is a fixed speed fan system 

and does not allow for variable speed control. It does 

not use the speed control unit or the heat sensor used 

in the FK24 Kit.
Specifications
115 Volts / 60 Hz / 56 Watts.
Maintenance
The fan itself does not require regular maintenance, 

however periodic cleaning of the fan and the 

surrounding area is required. 
Check the area under the control door (lower louvre 

assembly) and in front of the fan and wipe or vacuum 

this area at least once a month during the operating 

season.
Installation
The fan assembly is supplied fully wired eliminating 

the need for a licensed electrician to carry out the 

installation.
1.  Open the lower Louvre assembly. Move the fan & 

bracket assembly around the gas valve and lines to 

locate the unit against the back wall of the  

appliance, resting on the base.

2.  With the protective cover removed from the self-

adhesive ʻVelcroʼ strips apply mild pressure to the 

fan & bracket unit to secure the strips to the metal 

panels. No further securing is required. 

3.  Power to the fan can be supplied by plugging the 

supplied lead into a conveniently located wall socket 

or by using a hard-wired EB-1 receptacle box.

FP1230

FK24

fan install

11/02

Thermal 

Sensor

Fan

Fan Speed 

Switch

Gas 

Lines

Valve

EB-1 Recep-

tacle Box

FP1230

Fig. 54  FK24 fan placement.