Справочник Пользователя для Regency P40-NG1

Regency

®

 P40-1 Direct Vent Gas Fireplace

INST

ALLA

TION

1  

    910-462  

LP Conversion Coil

1      910-037  

LP Pilot Orifi ce

1      904-345  

Orifi ce #53

1      904-575  

Orifi ce #55

1      904-529  

Allen Key

1      918-590  

LP Conversion Decal

1      908-528  

Red Propane Label

1      918-587  

Instruction Sheet

  Turn control knob to the OFF position; 

  Remove the louvers and the fl ush door.

  Remove the logs.

  Remove the Steel Fender, by loosening 

the retaining srews on both sides and slid-
ing it out of place.

  Remove the front air box by undoing the 3 

screws.

  Loosen the air shutter adjustment screw and 

pull out the air shutter adjustment wire.

  Remove the 2 screws on the back burner.

  Slide the burner to the right and lift out.

  Remove the front burner by removing the 2 

screws. Lift the burner up and swing to the 
right and slide out.

 Replace the rear burner orifi ce with #53, 

using a 1/2" wrench. See image below. 
Use another wrench to hold onto the elbow 
behind the orifi ce. 

 Replace the front burner orifi ce with #55, 

using a 1/2" wrench. See image below. 
Use another wrench to hold onto the elbow 
behind the orifi ce. 

Remove the  pilot shield by removing the 2 
screws.

 Remove the pilot head from the assembly 

using a fl at head screw driver to pop out.

 Remove the NG pilot orifi ce with the Allen 

Key and replace with LP pilot orifi ce. Reat-
tach pilot head and clip.