Справочник Пользователя для Regency P40-NG1

Regency

®

 P40-1 Direct Vent Gas Fireplace

INST

ALLA

TION

1  

    910-463  

NG Conversion Coil

1      910-036  

NG Pilot Orifi ce

1      904-644  

Orifi ce #35

1      904-568  

Orifi ce #44

1  

    910-249  

J9 Jumper

1      904-529  

Allen Key

1      908-514  

NG Conversion Decal

1      908-529  

NG Yellow Label

1      918-719  

Instruction Sheet

  Turn control knob to the OFF position; 

  Remove the louvers and the fl ush door.

  Remove the logs.

  Remove the Steel Fender, by loosening 

the retaining srews on both sides and slid-
ing it out of place.

  Remove the front air box by undoing the 3 

screws.

  Loosen the air shutter adjustment screw and 

pull out the air shutter adjustment wire.

  Remove the 2 screws on the back burner.

  Slide the burner to the right and lift out.

  Remove the front burner by removing the 2 

screws. Lift the burner up and swing to the 
right and slide out.

 Replace the rear burner orifi ce with #35, 

using a 1/2" wrench. See image below. 
Use another wrench to hold onto the elbow 
behind the orifi ce. 

 Replace the front burner orifi ce with #44, 

using a 1/2" wrench. See image below. 
Use another wrench to hold onto the elbow 
behind the orifi ce. 

Remove the  pilot shield by removing the 2 
screws.

 Remove the pilot head from the assembly 

using a fl at head screw driver to pop out.

  Remove the LP pilot orifi ce with the Allen Key 

and replace with NG pilot orifi ce. Reattach 
pilot head and clip.