Справочник Пользователя для Vermont Casting 2477CE

12

6.  Reposition the stove so the other front corner over-

hangs the pallet and remove the leg bolt from the 
bottom of the stove. Align the leg with the bolt hole 
in the bottom of the stove, and attach it with the bolt 
and washer. Tighten securely.

7.  Reposition the stove so the first rear leg can be at-

tached. Attach the leg using the procedure described 
in Step 6. (Fig. 17)

8.  Reposition the stove so the remaining leg can be 

attached. Attach it using the procedure described in 
Step 6. Remove the pallet from beneath the stove. 

9.  Remove the (4) 1/4-20 x 3/8” hex head bolts from 

the mounting bosses and attach the bottom heat 
shield using the same bolts.

Carefully move the stove to its final position. One way 
to lessen the effort of moving the stove over smooth 
flooring is to slide it on a piece of inverted carpet. Move 
it slowly to ensure the floor is not scratched.
Retighten all leg fastening hardware.

ST815

back leg

6/04

ST815

Fig. 17  Reposition stove so one rear leg can be attached.

1.  Secure the fan assembly to the inner back with two 

(2) 1/4-20 x 3/4” hex head screws and one (1) 1/4” 
star washer as shown in Figure 18.

2.  Attach snapstat to the mounting holes on the un-

derside of the bottom with two (2) 1/4-20 pan head 
screws.

3.  Attach the rheostat to the door handle insert holder 

near the front left leg. Insert the rheostat control 
shaft through the handle holder hole. Install the 
retaining ring and rheostat knob onto the shaft.

4.  Place cables where they won’t be harmed by traffic.
5.  Fan will not operate until stove reaches approxi-

mately 43° C (109° F).

ST816

fan install

6/04

Rheostat 

Knob

Rheostat

Snapstat

Pan 

Head 

Screws

Fig. 18  Fan installation.

ST816