Справочник Пользователя для Hitachi RAS-SX10HAK / RAC-SX10HAK

Address

Address

•  Use two AAA-size batteries.

RESET

Press the 

 (TIMER) button to adjust to the current time.

•  You can fast forward the time by continuously pressing the 

button.

 

Confirm the current time
•  Press the 

 (SET TIME) button to check the current time 

(The time display disappears 3 minutes later). If necessary, 
readjust the time following the above procedure 1 and 2.

•  Address selector switch is used to prevent 

remote controller signal interference in such 
circumstance where 2 indoor units are used in 
the same room. This switch is not usually used. 
(The factory setting is at “A” side.)

  For this setting, please make an inquiry to your 

sales agent.

Switch lever

Remote controller

backside

Push 

 mark 

and pull.

Time is incremented

Time is decremented

Press 

 (SET TIME) button to set the current time.

•  “AM” or “PM” is lit instead of 

blinking. It automatically goes 
off in 10 seconds.

•  18:88 lights up on the current 

time display and “AM” and 
“PM” start blinking.

1. Do not mix new and old batteries, or 
 

different type of batteries together.

2. Remove the batteries when you do
 

not use the remote controller for 2 or 3 

 months.

– 11 –

C

M

Y

CM

MY

CY

CMY

K

EN_11.ai   2010-7-7   15:10:57

EN_11.ai   2010-7-7   15:10:57