Справочник Пользователя для Hitachi RAS-SX10HAK / RAC-SX10HAK

While 

 (SAVE) is blinking, point the remote controller towards 

the unit and press the 

 (ON/OFF) button.

•  A short beep sounds and   (SAVE) indicator turns on.

Press the 

 (FUNCTION SELECTOR) 

button until 

 (SAVE) blinks.

Press the 

 (FUNCTION SELECTOR) button again until 

 

(SAVE) blinks.
While 

 (SAVE) is blinking, point the remote controller towards 

the unit and press the 

 (ON/OFF) button.

•  A short beep sounds and   (SAVE) indicator turns off, indicates 

the setting is released.

 

Notes for “save” setting
•  If ampere is set to “Save”, the maximum heating capacity slightly lowers 

and starting up of heating operation will take a little longer. Besides, 
the preset temperature may not be reached if outside temperature is 
low.

• Point the remote controller to the signal receiver of the unit 
  Signal reception distance is approximately 7m in front of the unit. 

However, this distance may be shorter or the signal may not be 
receivable if there is an electronic lighting device in the same room.

• Handle the remote controller with care 
  Dropping it or getting it wet may compromise its signal transmission 

capability. After new batteries are inserted into the remote controller, 
the unit require approximately 10 seconds before it can respond to 
commands and begin operation.

Approximately 
7m from the front

If you experience frequent circuit breaker tripping, set ampere to “Save” to avoid this problem.
(Ampere is set to “Standard” at the time of purchase.)

– 12 –

C

M

Y

CM

MY

CY

CMY

K

EN_12.ai   2010-7-7   15:11:17

EN_12.ai   2010-7-7   15:11:17