Справочник Пользователя для Bard PA13422-C

Manual 2100-467K 

Page 

22 of 24

Compliant Scroll compressors have copper plated 
steel suction and discharge tubes.  These tubes are far 
more rugged and less prone to leaks than copper tubes 
used on other compressors.  Due to different thermal 
properties of steel and copper, brazing procedures may 
have to be changed from those commonly used.

•

  To disconnect:  heat joint Areas 2 and 3 slowly and 

uniformly until braze material softens and the tube 

can be pulled out of suction fitting.  (See Figure 9.)

•

  To connect:

 

–  Recommended brazing materials:  silfos with  
 

minimum 5% silver or silver braze material with  

  flux.

  –  Reinsert tube into fitting.

 

–  Heat tube uniformly in Area 1 moving slowly to  
 

Area 2.  When joint reaches brazing  

 

 

temperature, apply brazing material.  (See  

 

Figure 9)

 

–  Heat joint uniformly around the circumference  

  to flow braze material completely around the  
 joint.

 

–  Slowly move torch into Area 3 to draw braze  
 

material into joint.  (See Figure 9.)

 – 

Do not overheat joint.