Справочник Пользователя для Regency F37-LPG
14
F37 Regency
®
Rear Flued Room Sealed Freestanding Gas Heater
INSTALLATION
C)02-44
AERATION
ADJUSTMENT
The burner aeration is factory set but may need
adjusting due to either the local gas supply, air
supply or altitude.
adjusting due to either the local gas supply, air
supply or altitude.
NG: 10mm open
LPG: 10mm open
The aeration adjustment gears are located on
the right side of the burner box and can be ac-
cessed from the side or from the front when the
louvres are removed.
the right side of the burner box and can be ac-
cessed from the side or from the front when the
louvres are removed.
To adjust the aeration: use the allen key to turn
the turning gear which will adjust the air shutter.
Open the air shutter for a blue fl ame or close it for
a yellower fl ame. This adjustment is performed
by an authorized installer. The factory setting
should be suffi cient for most installations.
the turning gear which will adjust the air shutter.
Open the air shutter for a blue fl ame or close it for
a yellower fl ame. This adjustment is performed
by an authorized installer. The factory setting
should be suffi cient for most installations.
Clockwise to open,
counter-clockwise to close.
Caution: Carbon will be produced if the air
shutter is closed too much.
shutter is closed too much.
Note: Any damage due to carboning result-
ing from improperly setting the aera-
tion controls is NOT covered under
warranty.
tion controls is NOT covered under
warranty.
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit contains the following:
a) 02-65 Rear
Log
b) 02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left
c) 02-44 Front Left Log
d) 02-46 Left
Top
Log
e) 02-45 Front Right Log
f) 02-47 Center
f) 02-47 Center
Log
g) 02-48 Middle Right Log
h) Embers
h) Embers
902-151
i) Lava
902-154
Note: Install Optional Brick Panels prior to
installing logs.
Embers
Embers
The "02" refer numbers (i.e. 02-65) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
with care - do not force into position.
2) Sprinkle the embers on the left and right
sides of the fi rebox base.
Pins on Rear Log Support
A)02-65
B)02-56
3) Place Rear Log A)02-65 on the two pins on
the rear log support.
4) Place the Middle Left Log B)02-56 on the
two pins as shown.
5) Sprinkle some lava rock just in front of B)
02-56 on the burner holes.
lava rock
B)02-56
6) Place Front Left Log C)02-44 onto the 2
front pins as shown.