Справочник Пользователя для Regency F37-LPG

F37 Regency

®

 Rear Flued Room Sealed Freestanding Gas Heater

15

4)  The latches should already be at the proper 

setting.  If they are too hard or too easy 
to close, you may want to adjust them by 
loosening the locking nut and turning the 
latch catch.  See diagram 3.

5)  Remove the blue plastic protective coating 

from the glass. 

6)  Test the seal around the door by placing 

a piece of paper between the unit and 
the door, close the door and try to pull 
the paper out. If it slips out easily, then 
the door is not properly sealed. Tighten or 
loosen the latch by turning the latch catch 
inward or outward.  See diagram 3.

1)  Open the two side panels.

2)  Slide the door 

onto the two 
hinge pins mak-
ing sure the 
two pieces are 
fl ush together.  
See diagram 
1.

3)  Close the door. The 

latch plate must be 
centered around the 
alignment pin.  See 
diagram 2.  If the latch 
plate interferes with the 
corner of the stove you 
may want to angle the 
plate slightly so the door 
closes easier.

7)  Place the Left Top Log D)02-46 on the pin 

on Log  B)02-56 and on top of the cutout 
on Log A)02-65.

8)  Place Front Right Log E)02-45 on the two 

pins as shown.

9)  Place  the lava rock in the area between 

the left and right logs, leaving a space in 
the middle for log (F) 02-47.

10) Place the notch in Center Log F)02-47 over 

Log E)02-45 and across the cutout on Log 
A)02-65.

11) Position notch in Front Right Log G)02-48 on 

Log F)02-47 and push the bottom right edge 
against the bracket on the burner tray.

12) Test fi re to ensure proper light off (make sure 

fl ame fl ows smoothly from one end of burner 
to the other.  If there is any fl ame hesitation, 
check that area for any blockage of the burner 
port.