Справочник Пользователя для Quadra-Fire 31M-ACC-MBK

Page  34

7033-277C

March 2, 2007

R

1.   Remove all ash from the fi rebox, and extinguish all hot 

embers before disposal into a metal container.

2. The baffl e board has 2 pieces.  With the ceramic blanket 

still in place, slide one baffl e piece over the top of other one 
and pull out top piece through the door opening and then 
remove bottom baffl e piece.  Figure 34.1

3.  Remove the ceramic blanket.

4.  Re-install the baffl e pieces one piece at a time.  Be sure 

the baffl e boards are even with the front manifold tube and 
is resting on all tubes. Figure 28.1 on page 28.

5.  To re-install the ceramic blanket, it is easier to fold it in 

half fi rst.  Place on top of baffl e board, open up and fl atten 
and smooth out the blanket.  Re-check the baffl e board for 
correct positioning.  Figure 34.2.

Figure 34.1 - Baffl e 

Magnet

Spade

Connectors

Snap Disc

1.   Locate the snap disc bracket assembly at the bottom left 

rear corner of the stove.  Figure 34. 3

2.  A magnet holds the bracket to the stove.  Pull the bracket 

down away from the stove to expose the snap disc.

3.  Pull the snap disc and spade connectors up and out of 

bracket as shown in Figure 34.4.

4.  Using a Phillips head screw driver, remove the 2 screws 

from the snap disc and then remove the snap disc from 
the spade connectors.  Replace with new snap disc and 
re-connect to spade connectors.

5.  Push the snap disc and spade connectors back inside 

bracket and re-attach the bracket to the stove.

Snap Disc Location