Руководство Пользователя для Panasonic SKS-HT750
En-
5
Caution:
A mounting screw’s ability to support a speaker depends
on how well it’s anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 3/8" or less and a
shank diameter of 1/8" or less. With hollow walls, use a
cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of between 1/4" and 5/16" between the wall
and the base of the screw head, as shown.
on how well it’s anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 3/8" or less and a
shank diameter of 1/8" or less. With hollow walls, use a
cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of between 1/4" and 5/16" between the wall
and the base of the screw head, as shown.
(We recommend that you consult a home installation
professional.)
professional.)
A
STANDBY/ON indicator
Red:
Subwoofer in standby mode
Blue:
Subwoofer on
With the Auto Standby function, the SKW-750
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-750 automatically
enters Standby mode.
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-750 automatically
enters Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
woofer.
C
LINE INPUT
This RCA input should be connected to the sub-
woofer pre out on your AV receiver, amp, or other
receiver with supplied RCA cable.
woofer pre out on your AV receiver, amp, or other
receiver with supplied RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
your receiver or amp.
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
your receiver or amp.
1/4"–5/16"
Wall
Subwoofer (SKW-750)
2
3
1
■ Rear
To AC outlet
■ Front
SKS-HT750_En,Fr,Es.book Page 5 Thursday, July 19, 2007 10:03 AM