Справочник Пользователя для Shark SV7729N

1. Place the vacuum cleaner and 

charging adapter near an electrical 
power outlet (120 V., 60 Hz.) and plug 
in the charging adapter‘s jack into the 
vacuum.

2. Plug the charger into wall outlet.
3. The charging indicator light will shine 

red to indicate that the charging jack is 
properly inserted into the charging 
receptacle at the rear of the unit and 
that the unit is being charged. (Fig. 1)

1. This cordless hand vacuum is 

powered by rechargeable nickel-
cadmium batteries. Before using the 
vacuum, charge the vacuum cleaner 
for a minimum of 20 hours.

Note: Ensure that the On/Off switch is 
in the “Off” position before charging.
Note: Peak performance may only be 
realized after the unit has been charged 
and discharged two (2) or three (3) times.

To maintain peak 

performance of your cordless hand 
vacuum, it is recommended that the unit 
be fully discharged, then completely re-
charged at least once a month.

1. Charge for a minimum of 20 hours 

before initial use. Failure to do so 
will reduce the product’s battery life 
significantly.

2. Do not store the unit with the 

charging adaptor attached and 
plugged in.

3. Only recharge when the batteries 

are fully discharged (or as close to 
fully discharged as possible).

4. Do not store in areas of high 

temperature or humidity.

5. Fully discharge, then completely 

re-charge the unit at least once a 
month.

6. After three (3) months of storage, the 

product should be fully discharged 
and then recharged to maximize 
battery power.

7. Use only the charger supplied with 

the product. If other chargers are 
used, the batteries can fail causing 
damage to the battery, product or 
personal property. 

8. Ni-Cd batteries have a long useful life 

but at some time they will need to be 
replaced. To purchase replacement 
batteries visit www.sharkvac.com.

Note:
1. The on/off switch must be in the 

“OFF” position in order to charge the 
unit. If the charging indicator does not 
light, depress the on/off switch once.

2. If the product has never been used or 

has been stored for an extended 
period of time without use – it will take 
several complete charge and 
discharge cycles to realize the full 
operational time of your product.

4. The normal full charging time for this 

vacuum is 20 hours. The vacuum 
cleaner will run for maximum  
operational time only if it has been 
fully charged. To fully charge the unit, 
run the vacuum cleaner until it stops, 
then fully recharge the battery.

: 

NEVER use ordinary 

batteries for replacement, as these may 
leak and damage your vacuum cleaner. 
Use only battery pack XB7729 provided 
by EURO-PRO Operating LLC for 
replacement.
This vacuum cleaner contains a nickel-
cadmium (Ni-Cd) batteries, which must 
be recycled or disposed of properly in 
accordance with state, federal and local 
laws. Call your nearest recycling center 
for information on the recycling and 
disposal of nickel-cadmium (Ni-Cd) 
batteries.
If uncertain as to how to remove the 
battery pack, we suggest you take your 
wet/dry hand vacuum to a reputable 
small appliance service technician to 
have this service preformed.
The battery pack of your SV7729 is 
replaceable, however care should be 
taken when doing so. Follow these steps 
when replacement is required:
1. Open the battery pack compartment 

by removing the single Phillips head 
screw located in the recess at the 
rear of the unit. NEVER open the 
battery compartment except to 
change the battery pack when 
required.

2. Remove battery compartment cover. 

Set aside battery compartment cover 
with the screw.

3. Carefully detach the two (2) electrical 

connectors from the battery pack by 
pulling straight out from the battery 
pack.

4. Lift out the battery pack and set 

aside.

5. Insert the new battery pack and re-

connect the terminals by pushing lead 
wires onto battery tabs.

6. Tuck the wiring inside the battery 

compartment so that the wiring does 
not interfere with the battery 
compartment cover when it is 
replaced.

7. Re-install the battery compartment 

cover by sliding it over the battery 
towards the front of the unit, making 
sure that the front snap engages the 
body of the unit.

8. Replace the battery compartment 

cover screw.

: NEVER use the unit without 

the battery compartment cover in place.
Note: Any other servicing should be 
performed by an authorized service 
representative.

•

Use only with the battery pack 
supplied with the unit.

•

Do not attempt to remove the battery 
pack from the unit to charge it.

•

Never attempt to throw the battery 
pack or unit into a fire or incinerate it.

•

Do not attempt to remove or damage 
the battery casing.

•

Battery must be recycled or disposed 
of properly at the end of it's service 
life.