Справочник Пользователя для Shark EP710

Fig. 1

1. Remove the screw located just below 

the top edge of the back of the 

vacuum. (fig. 1)

1. Make sure that the quick release 

cord holder is in the upright 

position.

2. Remove the wire tie from the 

power cord.

3. Wrap the cord into place by 

wrapping it in a clockwise direction 

around the quick release cord 

holder and the lower cord holder 

as shown. (fig. 3)

2. Position the handle as shown in fig. 2.

Fig. 2

3. While holding the power cord out of the 

way, slide the handle into the opening at 

the top of the vacuum.

4. Insert the screw so that it passes 

through the handle into the vacuum.

5. Begin to tighten the screw with your 

fingers. It may be necessary to adjust 

the handle slightly. Using a screwdriver, 

tighten the screw.

Fig. 3

4. Turn the quick release cord holder 

to the left or to the right to unwrap 

the power cord. (Fig. 4)

Fig. 4

After the handle has been assembled to 

the body of the vacuum and the power 

cord has been wrapped around the 

cord holders, the attachments can be 

assembled.

1.

Insert the end of the hose into one 

of the extension tubes and place 

this extension tube into the slot of 

the inlet hose.

2.

Loop the loose hose over the hose 

hook.

3.

Place the other extension tube into 

the extension tube holder.

4.

Slide the crevice tool inside the 

extension tube when not in use.

5.

Place the dusting brush into the 

dusting brush holder.

To select a pile height setting:

1. Turn vacuum cleaner "Off".

2. Select a pile height setting by tilting 

the vacuum cleaner back until the 

front wheels are lifted slightly off the 

floor.

3. Slide the adjustment lever to the 

desired setting. (Fig. 6)

Suggested Pile Height Setting:

You may need to raise the height of the 

vacuum to make some jobs easier, 

such as scatter rugs and longer pile 

carpets.  Suggested settings are:

HIGH:

shag carpet, long pile, plush 

scatter rugs

MED:

medium to long pile

LOW:

short to medium pile, bare 

floors

EX LOW: very low pile, bare floors
Place unit in "HIGH" setting when using 

attachments to prevent possible floor 

damage.
Attention: Special care is required 

when vacuuming certain types of carpet 

or floor covering. Always check the 

carpet or floor covering manufacturer's 

recommended cleaning instructions 

before vacuuming.

Always remove the power plug 

from the wall outlet before assembling or 

removing accessories.

The upright vacuum can be used on 

multiple types of carpeting, bare floors 

or upholstery with attachments. When 

using the attachment tools such as the 

crevice tool and the dusting brush, 

place the handle of the vacuum in the 

upright position. (Fig. 5)

1.

Turn the quick release cord holder 

to either side 180° to release the 

power cord.

2.

Plug the power cord into the 

electrical outlet.

3.

Step on the handle release pedal 

to release the handle.

4.

Step on the On/Off button to turn 

the vacuum "On".

Fig. 5

Fig. 6

5

4