Справочник Пользователя для Shark NH15

 1-800-798-7398

www.sharkclean.com

English

  Twist air-intake end of Hand Vac 

counter-clockwise and remove 
cylinder.

  Pull out Foam Filter.

  Rinse only the foam filter thoroughly 

in lukewarm water until the water 
runs clear.

  Squeeze filter and let air-dry for 24 

hours before replacing; do not use 
hair dryer or other heating methods 
to dry. 

  Re-insert Foam Filter. Grip cylinder 

and align black arrows with hollow 
arrows on Hand Vac. Twist clockwise 
to lock.

DO NOT operate the vacuum without 
ALL the filters in place.

DO NOT operate the vacuum with 
WET filters.

  To re-insert filters:

•  Place the Felt Filter into canister

body first. 

•  Next, place the Large Foam Filter.

•  And finally, place the Filter Frame

with Small Foam Filter tucked inside.

Align locking icons of the Dust Cup 
cylinder with hollow arrows on the 
Hand Vac  body. Twist clockwise to 
lock. 

 Handle now aligns with raised 

brackets of Dust Cup cylinder.

Your foam filters do not need 
replacement for the life of your 
vacuum.  However, it is important to 
clean filters on both ends of Hand 
Vac periodically to maintain peak 
performance.

 

DO NOT operate the vacuum without 
ALL the filters in place.

 

DO NOT operate the vacuum with 
WET filters.

 

NOTE:  The white filters will discolor 
over time; this is normal and will not 
affect the performance of the filters 
or the vacuum.  

 

NOTE:  If Hand Vac is attached to 
Hose and Backsaver™ Wand in Stick 
Vac mode, remove  first before 
emptying contents. 

  Grip raised brackets (on either side 

of Dust Cup Release Button). Twist 
Dust Cup cylinder counter-clockwise 
and remove.

  Set dustcup aside.

  Pull out gray tray with Foam Filter 

insert. Pull out Foam and Felt Filters.

  Rinse all filters thoroughly in 

lukewarm water until the water runs 
clear.

  Squeeze filters and let air-dry for 24 

hours before replacing; do not use 
hair dryer or other heating methods 
to dry. 

 Make sure all filters are completely

dry before inserting back into 
canister body.