Справочник Пользователя для Samsung DJ68-00264B

14_ Maintain tools and filter

Maintain tools and filter

You should check your vacuum cleaner’s rotating floor brush and drive belt 

regularly for wear or damage. You should also clean the brush and brush ends 

of strings, hair, and carpet fibers. These can wrap around the brush and hamper 

its ability to effectively clean your carpet. Also remove any debris that has 

accumulated under the brush cover.

     check rotating Floor Brush and drive Belt

1. Unplug cleaner from electrical outlet.
2.  Recline handle and turn vacuum cleaner over so 

bottom side is up.

3.  Remove the six screws as shown with a phillips head 

screwdriver. Lift the brush cover off.

4.  Grasp rotating floor brush at both ends and lift.
5.  Clean strings, hair and other debris from rotating 

floor brush, paying particular attention to brush ends.

6.  Clean strings, hair and other debris from motor pulley 

and drive belt areas.

7.  Check drive belt carefully for wear, cuts or stressed 

areas.

8.  Check air passageway for obstructions. Remove 

debris from this area.

Rotating drum-brush could cause the fringe of a rug to become tangled within 

cleaner.

Use caution and turn off the drum-brush when vacuuming throw rugs with 

fringe.

     replace drive Belt

1. Unplug cleaner from electrical outlet.
2.  With rotating floor brush removed from vacuum 

cleaner grasp old drive belt and remove from motor 
pulley. Discard old drive belt.

3.  Place new drive belt over motor pulley and stretch 

other end over rotating floor brush in the space 
between the bristles.

4.  Place ends of rotating floor brush down into slots 

on sides as shown.

5.  T urn rotating floor brush by hand several times in
     the direction of motor pulley. If properly installed, 

drive belt will center itself on rotating brush crown.

6.  Reposition brush cover and screws. Tighten 

screws securely.