Краткое Руководство По Установке для Brother 885V95

Скачать
Страница из 196
90
UTILITY STITCHES
 — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — 
Note
z Do not lower the needle into fabric when 
aligning the marks. Desired results may not 
be achieved.
z When lowering the presser foot, do not push 
in the front of the presser foot.
a Do not reduce the gap.
f
f
Pull down the buttonhole lever as far as 
possible.
a Buttonhole lever
The buttonhole lever is positioned behind the 
bracket on the buttonhole foot.
a Buttonhole lever
b Bracket
g
Gently hold the end of the upper thread in 
your left hand, and then start sewing.
X
Once sewing is completed, the machine 
automatically sews reinforcement stitches, 
then stops.
h
Press 
(Thread cutter button) once.
a Thread cutter button
X
The threads are cut and the needle is raised.
i
Raise the presser foot lever, and then remove 
the fabric.
Memo
z If programmed thread-cutting is set, the 
sewing machine will sew reinforcement 
stitching, and then cut the thread 
automatically at the end of the stitching. 
Refer to "Automatically cutting the thread" 
(page 65).
z When you cut the threads by using the 
thread cutter on the side of the machine or 
scissors, first press
(Needle position 
button) once to raise the needle, then raise 
the presser foot lever and pull the fabric to 
the left side of the machine, and then cut the 
threads. Refer to "Using the thread cutter" 
(page 60).
j
j
Raise the buttonhole lever to its original 
position.
k
Insert a pin along the inside of one bar tack at 
the end of the buttonhole stitching to prevent 
the stitching from being cut.
a Pin
a
a
a
b
a
1