Справочник Пользователя для Brother 436C

8. ELECTRIC MECHANISM 

 

８

-５-３. DIP switches inside the control box 

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the 
wall outlet before opening the face plate of the control box. Touching areas where high voltages are 
present can result in severe injury. 

 

 

When opening the cover, hold it securely 
so that it does not fall down.

 

All DIP switches are set to OFF at the time of 
shipment. 

3616Q 

 

Switch 

Motion when set to ON 

DIP-1 

First two stitches are sewn at a low speed of 260 rpm. 

DIP-2 

Last two stitches are sewn at a low speed of 260 rpm. 

DIP-3 - 

DIP-4 

Last two stitches are sewn at a low speed of 700 rpm. 

DIP-5 

First two stitches are sewn at a low speed of 400 rpm. 

DIP-6 

Low speed sewing is not performed at the start of sewing. 

DIP-7 

The motor operates in reverse when the upper shaft stops, to return the needle 
bar to close to its highest position. 

*NOTE

 

Maximum area for the sewing data is increased. 

DIP-8 

<KE-436B, 436C> 
During an emergency stop, the thread is trimmed and the needle bar stops in the 
raised position. 

When the motor operates in reverse to raise the needle, the thread take-up will stop at a position which is 
lower than its normal stopping position. As a result, the thread take-up will rise slightly at the sewing start, 
and this may result in the thread pulling out under certain conditions. 

KE-430B, 430C series