Справочник Пользователя для Marantz SR4001

!0 Subwoofer 

Connect this jack to the line level input of a powered 
subwoofer. If an external subwoofer amplifi er is used, 
connect this jack to the subwoofer amplifi er input. If 
you are using two subwoofers, either powered or 
with a 2 channel subwoofer amplifi er, connect a “Y” 
connector to the subwoofer output jack and run one 
cable from it to each subwoofer amplifi er.

!1  7.1 CHANNEL or AUX2 INPUT 

By connecting a DVD Audio player, Super Audio CD 
multichannel player, or other components that has a 
multichannel port, you can playback the audio with 
5.1 channel or 7.1 channel outputs. 

!2  Multiroom Outputs (SR5001 only)

These are the audio output jacks for the Multi zone 
(Multi room).
Connect these jacks to optional audio power 
amplifiers to listen the source selected by the 
multiroom system in a remote room.

!3  REMOTE CONT. IN/OUT terminals

Connect to a Marantz component equipped with 
remote control (RC-5) terminals.

!4  AUDIO IN/OUT (CD, TAPE, CD-R, 

These are the analog audio inputs and outputs. There 
are 7 audio inputs (4 of which are linked to video 
inputs) and 4 audio outputs (2 of which are linked to 
video outputs). The audio jacks are nominally labeled 
for cassette tape decks, compact disc players, DVD 
players and etc.... The audio inputs and outputs 
require RCA-type connectors.

!5 DIGITAL 

These are the digital audio inputs and outputs. There 
are 2 digital inputs with coaxial jacks, 2 with optical 
jacks. 
The inputs accept digital audio signals from a CD, 
DVD, or other digital source component. 
For digital output, there is 1 coaxial output and 1 
optical output. 
The digital outputs can be connected to MD recorders, 
CD recorders, or other similar components.

!6 HDMI 

This unit has 2 HDMI inputs and 1 HDMI output. The 
input function can be selected from the OSD menu 
system. (See page 26)

!7  DC TRIGGER output terminal 

Connect a device that needs to be triggered by DC 
under certain conditions (screen, power strip, etc…) 
Use the system OSD setup menu to determine the 
conditions by which these jack will be active.

This output voltage is for (status) control only, It is not 
suffi cient for drive capability.

!8 FLASHER 

These terminals are to control the unit from each 
zone. Connect the control signal from a Keypad, 
etc.

!9  SPEAKER C SELECTOR SWITCH 

The terminals can be used to connect a third set of 
speakers by setting the SPEAKER C selector switch 
to ON. For connection and use, see page 23.

@0  XM antenna terminal (SR5001 only)

Plug the XM Connect-and-play antenna or Passport 
system into XM terminal.