Справочник Пользователя для Marantz SR4001

‹2 AUDIO 

Used to select one of the audio language.

‹3  TREBLE +/- buttons

These buttons are used to adjust the tone control of 
high frequency sound for left and right speaker.

‹4 SOURCE 

These buttons are used to switch the source of your 
A/V Receiver / amplifer. Each time a source button is 
pressed, the remote control changes to the source 
which was pressed.
This remote control can control 12 types of equipment. 
To change the A/V Receiver / amplifi er source, press 
this button twice within two seconds. The signal is 
sent when it is pressed the second time.

Select the AMP as the source to use this remote 
controll with the SR4001/SR5001.

‹5 Infrared 

This transmitter emits infrared light. Press the buttons 
while pointing the transmitter towards the infrared 
receiver window of the SR4001/SR5001 or other 
AV equipment. Be sure to also point towards other 
remote controls when using the learning function.

¤6  VOLUME +/- buttons

This button is used to adjust the volume for the 
amplifi er and television.

Set the AMP mode to use this button with the SR4001/
SR5001.

¤7 M-SPKR 

Used to turn on and off multi speaker.

¤8 MENU 

This button is used to call up the SETUP MAIN 
MENU of the SR4001/SR5001.

¤9 

1, 2, 3, 4 (CURSOR) / ENTER buttons

These buttons are used when controlling the cursor of 
the SR4001/SR5001, DVD or other AV equipment.

‹0 EXIT 

This button is used to cancel setting in the setup 
menu.

‹1 SUBTITLE/ATT. 

When the input signal is too high and the voice 
distorts even by throttling the SR4001/SR5001 
VOLUME control, turn on this function.
“

” is indicated when this function is activated.

The input level reduced. Attenuator is invalid for the 
output signal of “REC OUT”.

This function is unavailable while the digital input is 
selected.

¤1  BAND/LIP SYNC/INPUT button

Used to select a radio band.

Used to select LIP SYNC mode.

Used to select monitor input.

¤2 T.MODE 

Used to select auto stereo mode or mono mode 
when the FM band is selected.
The “

” indicator lights in the auto stereo mode.

¤3 P.SCAN 

Used to start preset scan.

¤4 MEMO/HT-EQ 

This button is used to store setting to memory or 
program a source.

Used to turn on or off HT(Home Theater)-EQ mode 
when the surround mode is set as AUTO, DOLBY, 
DTS or STEREO.
This mode compensates for the audio portion of a 
movie sounding “bright”.
When this button is pressed, “

” indicator light up.

¤5 MUTE 

This button is used to mute the audio for the amplifi er 
and television.

Set the AMP mode to use this button with the SR4001/
SR5001.