Справочник Пользователя для JVC UX-G5
24
Troubleshooting
If you are having a problem with your System, check this list
for a possible solution before calling for service.
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
you finish.
]
There is a time limit. Repeat the procedure again.
Operations are disabled.
]
The built-in microprocessor may malfunction due to
external electrical interference.
external electrical interference.
Unplug the AC power
cord and then plug it back in.
Unable to operate the System from the remote control.
]
The path between the remote control and the remote
sensor on the System is blocked.
sensor on the System is blocked.
]
Point it at the remote sensor on the front panel.
]
Signals cannot reach the remote sensor.
More closer to the System.
More closer to the System.
]
The batteries are exhausted.
No sound is heard from the speakers.
]
Speaker connections are incorrect or loose (see page 6).
]
Headphones are connected (see page 8).
Radio Operations:
Hard to listen to broadcasts because of noise (see pages 3
to 6).
to 6).
]
Antennas connections are incorrect or loose.
]
The AM loop antenna is too close to the System.
]
The FM antenna is not properly extended and positioned.
Disc Operations:
The disc does not play.
]
The disc is placed upside down. Place the disc with the
label side up.
label side up.
ID3 Tag on an MP3 disc cannot be shown.
]
There are two types of ID3 Tag—Version 1 and Version
2. This System can only show ID3 Tag Version 1.
2. This System can only show ID3 Tag Version 1.
The disc sound is discontinuous.
]
The disc is scratched or dirty.
The disc tray does not open or close.
]
The AC power cord is not plugged in.
]
Child Lock is in use (see page 17).
“MP3 DISC” appears while programming.
]
You have selected an MP3 disc while programming. You
cannot make a program using MP3 discs.
cannot make a program using MP3 discs.
Tape Operations:
The cassette holder cannot be opened.
]
Power supply from the AC power cord has been cut off
while the tape was running. Turn on the System.
while the tape was running. Turn on the System.
Impossible to record.
]
Small tabs on the back of the cassette are removed.
Cover the holes with adhesive tape (see page 19).
Cover the holes with adhesive tape (see page 19).
Timer Operations:
Daily Timer and Recording Timer does not work.
]
The System has been turned on when the on-time comes.
Timer starts working only when the System is turned off.
Timer starts working only when the System is turned off.
UX-G5[UJ].book Page 24 Friday, June 10, 2005 1:07 PM