Справочник Пользователя для Pelco IP110

12

C3432M-G  (4/09)

The IP110 Series Camclosure integrated camera system mounts only to a surface. It can be wired through 
the cover into a surface, electrical box, plaster ring, or through a side conduit opening. 

NOTE: A flash mount adaptor ring is available. Refer to the IP110-F Flush Mount Adaptor Installation 
manual (C2238M) for installation instructions.

1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the 

cover from the back box.

2. Cut out the hole for the cable and wiring. Pull the cable and wires through the mounting surface and 

then through the hole of the cover.

3. Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware 

when installing the system outdoors.

4. Install the camera module into the back box before installing the back box into the cover. Rotate the 

camera module to access the mounting holes inside the back box (refer to Camera Module on 
page 19 for more information).

5. Connect the cable and wires (refer to Wiring Tables on page 16 for information).

Figure 5.  Basic Surface Installation

6. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and 

washers (removed earlier) to secure the back box to the cover. 

COVER

BACK BOX

MOUNTING

SCREWS

(NOT SUPPLIED)

8-32 X 0.375-INCH

PHILLIPS PAN HEAD

SCREWS WITH WASHERS

(SUPPLIED)