Справочник Пользователя для Pelco IP110

14

C3432M-G  (4/09)

1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the 

cover from the back box. 

2. Pull the cable and wires into the cover. Use three 6-32 x 0.75-inch Phillips pan head screws 

(supplied) or two 8-32 x 0.75-inch Phillips pan head screws (supplied) to attach the cover to an 
installed 404 plaster ring. Use stainless steel hardware when installing the system outdoors.

3. Install the camera module into the back box before installing the back box into the cover. Rotate the 

camera module to access the mounting holes inside the back box (refer to Camera Module on 
page 19 for more information). 

4. Connect the cable and wires (refer to Wiring Tables on page 16 for information).

Figure 7.  404 Plaster Ring Installation

5. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and 

washers (removed earlier) to secure the back box to the cover.

6-32 X 0.75-INCH

OR 8-32 X 0.75-INCH

PHILLIPS PAN

HEAD SCREWS

(SUPPLIED)

8-32 X 0.375-INCH

PHILLIPS PAN HEAD

SCREWS WITH WASHERS

(SUPPLIED)

COVER

BACK BOX

CEILING/
WALL

404 PLASTER RING
(NOT SUPPLIED)