Справочник Пользователя для Pelco IP110
C3432M-G (4/09)
19
Camera Module
The IP110 Series Camclosure camera module includes the camera, camera bracket, and heater board.
To perform most camera adjustments, you must remove the module from the back box.
To perform most camera adjustments, you must remove the module from the back box.
Use the following instructions to install or remove the camera module.
CAMERA ORIENTATION
The camera module is configured for ceiling mounting at the factory. For wall mounting, you must change
the camera orientation or the video image will be upside down.
the camera orientation or the video image will be upside down.
To change the camera orientation (refer to Figure 12):
1. Remove the camera module from the back box (if necessary).
2. Remove the tilt adjustment screw and lock washer from each side of the camera.
3. Carefully rotate the camera one-half turn. Make sure the wiring harness does not bind.
4. Reinstall the tilt adjustment screw and lock washer on each side of the camera.
Figure 12. Camera Orientation
5. Verify the camera orientation.
BOTTOM
OF CAMERA
OF CAMERA
TILT ADJUSTMENT
SCREW AND
LOCK WASHER
SCREW AND
LOCK WASHER
CEILING MOUNT (DEFAULT)
WALL MOUNT
TOP OF
CAMERA
CAMERA
TILT ADJUSTMENT
SCREW AND
LOCK WASHER
SCREW AND
LOCK WASHER
WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting
the camera. This applies to all models.
the camera. This applies to all models.