Справочник Пользователя для Pelco IP110

20

C3432M-G  (4/09)

To install the camera module into the back box:

Figure 13.  Back Box Connectors

1. Plug the camera (10-pin), heater board (4-pin), and service (3-pin) connectors into the back box (refer 

to Figure 13).

HEATER
CONNECTOR

SERVICE
CONNECTOR

CAMERA
CONNECTOR

2. Make sure the tabs on the camera bracket and the service connector are pointing out of the 

enclosure and away from the ceiling or wall.

Figure 14.  Camera Module Bracket

3. Gently squeeze the bracket, place it against the groove inside the back box, and then gently release 

(refer to Figure 14).

BRACKET