Справочник Пользователя для Pelco DD53M22-X

C2443M-D (11/05)

15

Display setup allows you to program how labels are displayed on the monitor. The following
labels are available:

PRESET LABEL:

Identifies preset.

ZONE LABEL:

Identifies zone.

ZOOM RATIO:

Identifies the amount of magnification.

AZIMUTH

1

/ELEVATION

2

:

Amount of pan from 0° and the amount of tilt from 0° horizontal.

DIRECTION;

Displays compass direction.

ALARM MESSAGE:

Displays activated alarm.

A preset label is displayed when a preset is called. A zone label is displayed when the system
moves into a zone. The zoom ratio label is displayed when zoom is activated. Azimuth/elevation
and direction labels are displayed when pan/tilt is activated. An alarm message appears on the
monitor when an alarm occurs.

The following settings are available for each label:

OFF:

Label is not displayed when activated.

CONSTANT:

The label is continually displayed when activated.

2 SECONDS:

The label is displayed for 2 seconds after activation.

5 SECONDS:

The label is displayed for 5 seconds after activation.

10 SECONDS;

The label is displayed for 10 seconds after activation.

1

Azimuth is the pan angle from 0° to 359°.

2

Elevation is the tilt position from 0° (horizon) to -90°.

BACK
EXIT

PRESET LABEL

2 (SECS)

ZONE LABEL

2 (SECS)

ZOOM

2 (SECS)

AZIMUTH/ELEVATION

2 (SECS)

DIRECTION

OFF 

ALARM MESSAGE

2 (SECS)

<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS

DISPLAY SETUP

(See page 11)

EXIT

SPECTRA III

LANGUAGE ENGLISH

<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*

RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM

* This setting only applies to

Pressurized Spectra III SE dome
systems with software version
1.25 or higher.