Справочник Пользователя для Pelco DD53M22-X

16

C2443M-D (11/05)

Labels can be placed anywhere on the monitor. This feature allows you to customize the
appearance of your monitor screen.

The following labels are not set at fixed positions:

PRESET LABEL

ZONE LABEL

ALARM 1

ZOOM RATIO - XXX.XX

AZIMUTH

1

/ELEVATION

2

 - XXX°/-XX°

DIRECTION - NE

ALERT MESSAGE

3

*

TITLE TEXT

To set a label position:

1.

Use the joystick to position the cursor beside a label.

2.

Press Iris Open.

3.

Use the joystick to move the label up, down, left, and/or right.

4.

Press Iris Open.

5.

Repeat steps 1 through 4 to position other labels.

6.

Position the cursor next to Save and Exit. Press Iris Open to save settings and exit menu.

1

Azimuth is the pan angle from 0° to 359°.

2

Elevation is the tilt position from 0° (horizon) to -90°.

3  

The alert message is the warning displayed on the monitor if pressure, temperature, or dew
point inside the dome reach unacceptable levels.

BACK
EXIT

PRESET LABEL

2 (SECS)

ZONE LABEL

2 (SECS)

ZOOM

2 (SECS)

AZIMUTH/ELEVATION

2 (SECS)

DIRECTION

OFF 

ALARM MESSAGE

2 (SECS)

<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS

DISPLAY SETUP

EXIT

SPECTRA III

LANGUAGE ENGLISH

<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*

RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM

[ZONE LABEL-------]
[PRESET LABEL-------]
[ALARM 1-------]
[ALERT MESSAGE-------]*
[TITLE TEXT-------]

SAVE AND EXIT
CANCEL AND EXIT
HELP

XXX

0

/-XX

0

NE
XXX.XX

LABEL POSITION

* This setting only applies to

Pressurized Spectra III SE dome
systems with software version
1.25 or higher.