Справочник Пользователя для JVC TK-C215VP4

䡵 Mounting screws for the base

Be sure to use M4 screw.

䡵 Mounting the fall prevention wire

● Pay attention to the length, strength, routing 

and material (insulation properties) of the fall 
prevention wire used.

● The internal diameter of the rounded portion 

on the camera unit to which the fall 
prevention wire is to be mounted shall be at 
least 

R 4.1 mm and not larger than R 6.5 mm, 

and its external diameter shall not be larger 
than 

R12 mm.

● When mounting the fall prevention wire to the 

base, be sure to use the M4 screws mounted 
on the base.

䡵 Handling camera

● When mounting the base to the ceiling, or 

when connecting the cable of the camera 
unit, pay enough attention to the fall of each 
part.

When mounting this unit to the ceiling or wall, 
mount it to a secure location where it can 
support the mass of this unit. When mounting 
to an insecure location, make sure to carry out 
reinforcement of the ceiling or wall before 
installation.
The camera unit may fall if the mounting screw 
or piping is not properly tightened. Ensure that 
the screws and nuts are properly tightened.

Connect the fall prevention wire to prevent this 
unit from falling accidentally. The camera unit 
may fall if this wire is not connected.

8 mm

2 mm

Fall Prevention 
Wire

Base

R4 mm screw

M4 screw
(Attached to the base)

TK-C215VP4_JP.book  Page 2  Wednesday, September 20, 2006  6:02 PM