Справочник Пользователя для Petsafe PIG00-10773

16 

Proper grounding, although not necessary for the system to work, 
will help reduce the chance of electrical surges causing damage to 
your Fence Transmitter and/or Power Adapter. To ground your unit, 
you will need a stranded 10 gauge insulated copper wire and a UL 
approved grounding clamp to connect the wire to the grounding rod 
located at your electrical power service entrance. These items may be 
obtained at most local hardware or electrical supply stores. Connect 
one end of the Ground Wire to the Ground Terminal located on 
the Fence Transmitter and the other end of the Ground Wire to the 
grounding rod located at the electrical power service entrance to 
your home. This grounding rod is normally located below the electric 
meter mounted on your home. Secure the wire to the grounding rod 
using the UL approved grounding clamp. 

The Fence Transmitter is also equipped with a 250 volt, 1 amp 
fuse to protect the unit’s electronic circuitry from electrical power 
surges. To locate the fuse, slide off the lid on the back of the Fence 
Transmitter. A spare fuse is also provided.

Ground

Wire

Fuse

Spare Fuse

Run the Boundary Wire through a window, under a door, through a crawl space vent, or 

1. 

any other appropriate available access. you can also drill a hole through your wall.
Strip 

2. 

3

⁄

8

 inch of insulation from the ends of the Boundary Wire.

Press the red tabs on the Fence Transmitter and insert the opposite ends of the twisted 

3. 

wire into the Boundary Wire Terminals.
Turn the Boundary Width Control Knob to 10. This will set the Boundary Width at the 

4. 

maximum width.
Plug Power Adapter into Power Jack and AC Power Outlet.

5. 

The Power Light and Loop Indicator Lights should come on. If this does not happen see 

6. 

the “Troubleshooting” section.

Do not install, connect, or remove your system during a lightning storm. If the storm is 

• 

close enough for you to hear thunder, it is close enough to create hazardous surges.
Risk of electric shock. Use the Fence Transmitter indoors in dry location only.

• 

If possible, DO NOT use an AC circuit protected with a Ground Fault Circuit Interrupter 
(GFCI) or Residual Current Device (RCD). In rare cases, nearby lightning strikes may 
cause the GFCI or RCD to trip. Without power your dog may be vulnerable to escape. 
You will have to reset the GFCI or RCD to restore power to the system.

For added protection, when unused for long periods of time or prior to thunderstorms, 
unplug  from the wall outlet and disconnect the loop boundary wires. This will prevent 
damage to the transmitter due to surges.