Справочник Пользователя для Barco MDNC 4130
Configuring Windows
63
Configuring Windows
Setting the resolution of your B
ARCO
N
IO
F
USION
Display
Note: In order to set the resolution of your B
ARCO
N
IO
F
USION
Display you must be logged in using an account with
administrator privileges.
administrator privileges.
Accessing the Windows Display Control Panel
1.
Open the “Windows Display Control Panel” by one of the
methods below:
methods below:
a)
Start > Settings > Control Panel > Display
b)
Open the “Display Properties Control Panel” by right
clicking in an empty area on the desktop, then select
Properties.
clicking in an empty area on the desktop, then select
Properties.
c)
Windows Vista: Right click in an empty area on the
desktop, select “Personalization”, then click on “Display
Setting”.
desktop, select “Personalization”, then click on “Display
Setting”.
2.
Click on the Settings tab (the Settings tab is not present in
Vista).
Vista).
3.
Select the rectangle that represents the Barco display whose
settings you wish to change.
settings you wish to change.
Note: If you are using the VGA capabilities of your B
ARCO
MXRT
display controller, the resolution for the first display may be set
to a VGA resolution of “640 x 480” pixels with 16 colors and a
default refresh rate. If your B
to a VGA resolution of “640 x 480” pixels with 16 colors and a
default refresh rate. If your B
ARCO
MXRT controller is not running
VGA, the display may not be enabled yet. To enable the display,
check the “Extend my Windows desktop onto this monitor”
checkbox, but do NOT click the Apply button at this time.
check the “Extend my Windows desktop onto this monitor”
checkbox, but do NOT click the Apply button at this time.
If you installed your B
ARCO
N
IO
F
USION
Display System drivers in
SingleView mode (default for Windows 2000) there will be one