Справочник Пользователя для Land Pride RCF2784

12/15/15

Refer to Figure 2-3 & Figure 2-4:
Instructions for adjusting 3-Point tailwheel height is the 
same for single and dual tailwheels. If the front blade tip 
is set at the desired cutting height and the back blade tip 
is lower, at the same height, or higher than the front blade 
tip by more than 1" then the tailwheel(s) must be adjusted 
up or down as follows:

1.

Use tractor’s 3-Point hydraulic control to lift cutter 
until tailwheel(s) (#5) is off the ground.

2.

Remove hex nut (#3), lock washer (#4), and cap 
screw (#2).

3.

Adjust tailwheel as follows:

To lower rear blade, lift tailwheel(s) (#5) up.

To raise rear blade, lower tailwheel(s) (#5) down. 

4.

Reattach adjustment bar (#1) with existing 5/8" cap 
screw (#2), lock washer (#4), and hex nut (#3). 
Tighten nut to the correct torque.

5.

Readjust tractor’s lower 3-Point lift arms as needed. 
See “Cutting Height Adjustment” instructions on 
page 20.

1.

Lower cutter deck to a preset cutting height.

2.

Adjust length of center 3-Point link until upper center 
hitch pin is vertically above lower 3-Point hitch pins. 
This arrangement allows for optimum ground contour 
following performance.

3.

Lock center 3-Point link in this position.

NOTE: The following adjustments may be made if 
desired cutting height is located between two holes in 
tailwheel adjustment bar (#1).

1.

Unbolt adjustment bar (#1) from tailwheel pivot 
frame and deck mounting lugs. 

2.

Turn adjustment bar upside down and reattach it 
to the deck mounting lugs and tailwheel pivot 
frame using existing hardware. 

3.

Repeat steps 1 thru 5 above.

NOTE:  The lower bolted-on-bushing in the center 
hitch is used with a quick hitch attachment.

33031

33032

33033