Справочник Пользователя для Land Pride RCF2784
23
Section 2: Adjustments
12/15/15
RCF2784 Rotary Cutters 326-364M
Cutting Height Adjustment
!
WARNING
!
CAUTION
Hydraulic Cylinder Instructions
Refer to Figure 2-7:
At the front of the cutter, measure distance from cutting
tip of blade to ground. This distance is the cutting height.
Use tractor hydraulic cylinder control lever to change
cutting height.
tip of blade to ground. This distance is the cutting height.
Use tractor hydraulic cylinder control lever to change
cutting height.
1.
With tractor hydraulics, raise cutter fully up.
2.
Remove all stroke control spacers (#6) from cylinder
rod (#3) by spreading spacers apart at the break line.
rod (#3) by spreading spacers apart at the break line.
3.
Using tractor hydraulic cylinder control lever, lower
Rotary Cutter to the desired cutting height. Measure
this distance to verify cutting height is correct.
Rotary Cutter to the desired cutting height. Measure
this distance to verify cutting height is correct.
4.
Select required size and number of stroke control
spacers (#6) that will fill the exposed cylinder rod.
The following spacers are available.
spacers (#6) that will fill the exposed cylinder rod.
The following spacers are available.
•
Two 1" spacers
•
One 1 1/4" spacer
•
One 1 1/2" spacer
•
One 1 3/4" spacer
5.
Return to the tractor and raise Rotary Cutter up.
Install selected size and number of stroke control
spacers on the cylinder rod.
Install selected size and number of stroke control
spacers on the cylinder rod.
6.
Lower Rotary Cutter against stroke control spacers
and recheck cutting height. If needed, adjust size and
quantity of stroke control spacers until desired
cutting height is achieved.
and recheck cutting height. If needed, adjust size and
quantity of stroke control spacers until desired
cutting height is achieved.
Ratchet Jack Instructions
Refer to Figure 2-8:
At the front of the cutter, measure distance from tip of
front cutting blade to ground. This distance is the cutting
height. Use ratchet jack to change cutting height.
At the front of the cutter, measure distance from tip of
front cutting blade to ground. This distance is the cutting
height. Use ratchet jack to change cutting height.
1.
Raise cutter blades by setting ratchet jack lock and
pumping the ratchet jack lever back and forth to
lengthen ratchet jack until desired cutting height is
achieved.
pumping the ratchet jack lever back and forth to
lengthen ratchet jack until desired cutting height is
achieved.
2.
Lower cutter blades by reposition ratchet lock and
pumping the ratchet jack lever back and forth to
shorten the ratchet jack until desired cutting height is
achieved.
pumping the ratchet jack lever back and forth to
shorten the ratchet jack until desired cutting height is
achieved.
NOTE: Removing spacers lowers the cutting height
and adding spacers raises the cutting height.
and adding spacers raises the cutting height.
Deck Leveling & Hydraulic Height Adjustments
Figure 2-7
Ratchet Jack Adjustment
Figure 2-8
33275
33050
Ratchet Jack Lever
Ratchet Jack Lock