Справочник Пользователя для Radware VOYA-GRAND-MBK

September 25, 2012

7075-166

Page  23

R

1. Remove  all  ash  from  the  firebox,  and  extinguish  all  hot

embers before disposal into a metal container.

2.  It  is  easier  to  remove  both  baffle  boards  and  ceramic

blanket after the tube channel assembly has been partially

disassembled  and  the  right  side  lowered.    Follow  steps

1 through 4 on 

page 25 for removal of the tube channel 

assembly.  It is not necessary to completely remove the 

tube channel assembly.

3.  Once the baffle protection cover has been removed, pull

the baffle boards and ceramic blanket forward about 1 inch

(25mm) and then overlap the baffles about 1-2 inches (25-

51mm).  

Figure 23.2.

4.  Slide the tube channel assembly to the left as far as it will

go and lower the right side. Remove the baffle boards and

ceramic blanket together.

Figure 23.3. 

4.  Re-install in reverse order. Be sure the baffle boards and

ceramic blanket are in their proper positions.

1.  Install washer on door handle shaft.
2.  Slide door handle through door.

3.  Install additional washer(s) as shown in 

4.  Install key in groove.
5.  Align groove in latch cam with key; slide latch cam over

shaft

6.  Install locknut but do not overtighten, the handle needs

to move smoothly.

7.  Install handle turning in a counter-clockwise motion to

desired location on door handle rod.  

Locknut

Latch Cam

Spacing 

Washers

Door Cross 

Section

Square Key

Door Handle Shaft

Fiber Handle

Slide Tube Channel to the 

Left and Lower Right Side

Baffle Boards Overlapping

Ceramic Blanket