Справочник Пользователя для Radware VOYA-GRAND-PMH

September 25, 2012

7075-166

Page  25

R

2. Prior to installing, determine the following:

•  Type of chimney connector to be used

  · single wall, 6 inch (152mm) diameter, stainless steel, 

or

  · double wall, 6 inch (152mm) diameter, stainless steel

•  Consult

pages 31 and 32 for clearances to combustibles

•  Power outlet located close by for optional blower

Draft is the pressure difference needed to vent appliances 

successfully. When a appliance is drafting successfully, all 

combustion byproducts are exiting the home through the 

chimney.
Considerations for successful draft include:

•  Preventing negative pressure

•  Location of appliance and chimney

To be sure that your appliance burns properly:

•  During a low burn, the chimney draft (static pressure) should 

be approximately -.04 inch water column (W.C.)

•  During a high burn the chimney draft should be approximately

-.10 inch (W.C.)

•  Measure the W.C at 6 inches (152mm) above the top of the

appliance after one hour of operation at each burn setting.

NOTICE:  Hearth  &  Home  Technologies  assumes  no

responsibility for the improper performance of the appliance 

system caused by:

Check building codes prior to installation.
•  Installation  MUST  comply  with  local,  regional,  state  and

national codes and regulations.

•  Consult  insurance  carrier,  local  building,  fire  officials  or

authorities having jurisdiction about restrictions, installation

inspection, and permits.

•  DO NOT CONNECT THIS UNIT TO A CHIMNEY

FLUE SERVICING ANOTHER APPLIANCE.

•  DO NOT CONNECT TO ANY AIR DISTRIBUTION

DUCT OR SYSTEM.

May allow flue gases to enter the house.

•  Installation and use of any damaged appliance.
•  Modification of the appliance.
•  Installation  other  than  as  instructed  by  Hearth  &  Home

Technologies.

•  Installation and/or use of any component part not approved

by Hearth & Home Technologies.

•  Operating  appliance  without  fully  assembling  all

components.

•  Operating appliance without legs attached (if supplied with

unit).

•  Do NOT Overfire - If appliance or chimney connector glows,

you are overfiring.

Fire Risk.
Hearth & Home Technologies disclaims any

responsibility for, and the warranty will be 

voided by, the following actions:

•  Inadequate draft due to environmental conditions

•  Downdrafts

•  Tight sealing construction of the structure

•  Mechanical exhausting devices

•  Overdrafting caused by excessive chimney heights

•  Ideal performance is with height of chimney between

14-16 feet (4.26-4.88m) measured from the base of 

the appliance.

Quadra-Fire wood inserts are designed for factory-built non-

combustible  fireplaces  that  have  been  installed  in  accor-

dance with the National, Provincial, State and local building

codes.
1. Prior to installing the wood insert:
•  Have the chimney and adjacent structure inspected and

cleaned by qualified professionals. Heart & Home Tech-

nologies recommends that NFI or CSIA certified profes-

sionals,  or  technicians  under  the  direction  of  certified

professionals, conduct a minmum of a NFPA 211 Level 2

inspection of the chimney.

•  Replace component parts of the chimney and fireplace

as specified by the professionals.

•  Ensure all joints are properly engaged and the chimney is

properly secured.