Справочник Пользователя для Radware VOYA-GRAND-PMH

Page  36

7075-166

September 25, 2012

R

The chimney can be new or existing, masonry or prefabricated

and must meet the following minimum requirements:
 • Must be minimum 6 inch (152mm) inside diameter of

high temperature chimney listed to UL 103 HT (2100

o

F)

or ULC S628.

 • Must use components required by the manufacturer for

installation.

 • Must maintain clearances required by the manufacturer

for installation.

 • Refer to manufacturers instructions for installation

 •This  insert  is  listed  to  UL  1482  Standard  and  is

approved for installation into listed factory-built solid 

fuel fireplaces listed to UL 127 conforming to the follow-

ing specifications and instructions:

 •The  original  factory-built  clearance  fireplace  chimney

cap must be re-installed after installing the approved 

chimney  liner  meeting  type  UL  103  HT  requirements

(2100°F) per UL 1777.

 

•The  liner  must  be  securely  attached  to  the  insert  flue

collar and the chimney top. 

 •The  air  flow  of  the  factory-built  solid  fuel  fireplace

system must not be altered. The flue liner top support

attachment must not reduce the air flow for the existing

air-cooled chimney system.

 •No dilution air is allowed to enter the chimney.

   1. 

Secure the fireplace damper in the open position.

If this cannot be accomplished, it will be necessary 

to remove the damper.

   2. Seal  damper  area  of  chimney  around  chimney

connector with a high temperature sealant or seal 

insert against the face of the fireplace.

    3. Both methods must be removable and replaceable 

for cleaning and re-installation.

This insert conforms with the safety standard UL-1482 and

ULC S628 (Canada) in all respects and is approved to UL &

ULC safety standards for installation and use within a fire-

place with masonry chimney, in accordance with NFPA 211,

and CAN/CSA-B365-01.

Minimum Width of Cavity Opening - Front

32-7/8*

835

Minimum Width of Cavity Opening - Rear

24*

610

Minimum Height

24*

610

Minimum Depth from Front to Rear

18*

457

Fire Risk.
When lining air-cooled factory-built chimneys:.
•  Run chimney liner approved to UL 1777 Type

HT requirements (2100 degrees F)

•  Re-install original factory built chimney cap

ONLY

•  DO NOT block cooling air openings in chimney
•  Blocking cooling air will overheat the chimney

WARNING

NOTICE: In Canada when using a factory-built chimney it must

be safety listed,

“A” or conforming to CAN/ULC-S629M, STANDARD FOR 

To  maintain  the  functionality  of  the  fireplace’s  chimney

system  you  may  use  a  Simpson  Dura-Vent  DuraLiner

Slip Hanger, Part # 4671, and attach to the bottom of the

fireplace chimney cap to support the liner. You have two

options to completing the installation.

Option one - Not required to use liner cap:

Re-attach the existing top of the chimney cap.  

Option two - Using liner cap: 

Re-attach the existing top of the chimney cap and install a 

new storm collar and a new liner cap.