Справочник Пользователя для Radware VOYA-GRAND-PMH

September 25, 2012

7075-166

Page  37

R

The following  modifications  of factory-built  fireplaces  are

permissible:

•

The fireplace must not be altered, except that the damper

may be removed to accommodate a direct-connect starter 

pipe or chimney liner,

•  E

xternal trim pieces which do not affect the operation 

of the fireplace may be removed providing they can be

stored  on  or  within  the  fireplace  for  reassembly  if  the

insert is removed.

•

The  permanent  metal  warning  label  provided  in  the

component  pack  must  be  attached  to  the  back  of  the

fireplace, with screws or nails, stating that the fireplace

may have been altered to accommodate the insert, 

and must be returned to original condition for use as a 

conventional fireplace.

Figure 37.2.

•

Manufacturer  designed  adjustable  support  kit  can  be

ordered from your dealer.  

•

Final approval of this installation type is contingent upon

the authority having jurisdiction.

Damper

Smoke Shelf or Baffle

Ember Catches

Fire Grate

Viewing Screen/Curtain

Doors

LINER CONNECTOR

FLUE

 GAS 

DIRECTION

CRIMPED 

END 

TOWARDS 

STOVE

All  joints  should  be  secured  with  3  sheet  metal  screws  or

rivets per pipe manufacturers instructions. The sections must

be attached to the insert and to each other with the crimped 

(male) end pointing toward the insert.  

Figure 37.1.

250-2061

THIS FIREPLACE MAY HAVE BEEN ALTERED

TO ACCOMMODATE AN INSERT.  IT MUST BE 

RETURNED TO ITS ORIGINAL CONDITION 

BEFORE USE AS A SOLID FUEL BURNING 

FIREPLACE.

250-2061

A permit may be required for installations, final approval is

contingent of the authority having local jurisdiction.

Consult

insurance carrier, local building, fire officials or authorities

having  jurisdiction  about  restrictions,  installation  inspec-

tion, and permits

.

Inspect the existing fireplace and chimney for any damage

or flaws such as burnouts, metal or refectory warping.

Inspection to a minimum of NFPA 211 Level II is recom-

mended. All repairs must be made prior to installing an

insert.    The  fireplace  must  be  structurally  sound  and  be

able to support the weight of the solid-fuel insert

The factory-built chimney must be listed per UL 127 or ULC

610-M87 for all installations.  Install thermal protection per 

this appliance listing requirements.

The flue liner top support attachment must not reduce the

air flow for the existing air-cooled chimney system. Re-

install original factory-built chimney cap 

only. (See Sec-

tion F., Prefabricated Metal Chimney)

To prevent room air passage to the chimney cavity of the

fireplace, seal either the damper area around the chimney

liner or the insert surround. Circulating air chamber (i.e. in

a steel fireplace liner or metal hearth circulator) may not

be blocked. The air flow within and around the fireplace

shall not be altered, blocked by the installation of the insert.

(i.e. no louvers or cooling air inlet or outlet ports may be 

blocked by the insert or the insert surround.

See “H. Altering the Fireplace” for modifications allowed for

factory-built fireplaces.