Справочник Пользователя для Radware VOYA-GRAND-PMH

September 25, 2012

7075-166

Page  39

R

 •  4  inch  flex  aluminum  pipe,  or  if  using  alternate  material,

then it shall be made from durable, non-combustible, heat 

resistant material up to 350

o

F. Cut the pipe to the required

length for your installation. 

 • Phillips head screw driver
 • Silicone sealant

A source of air (oxygen) is necessary in order for combustion to

take place. Whatever combustion air is consumed by the fire

must be replaced. Air is replaced via air leakage around win-

dows and under doors. In homes that have tightly sealed doors 

and windows, an outside air source is needed. An optional Out-

side Air Kit is available. 

Do not draw outside combustion air from:
•  Wall, floor or ceiling cavity

•  Enclosed space such as an attic or garage

•  Close proximity to exhaust vents or

chimneys

Fumes or odor may result

Asphyxiation Risk.
Length of outside air supply duct shall NOT exceed

the length of the vertical height of the exhaust flue.
•  Fire will not burn properly
•  Smoke spillage occurs when door is opened due

to air starvation.

Option One - Outside Air Installation Instructions
1.  Swing grille down to expose the two screws.

2.  Remove the two screws and pull the access assembly 

away from the appliance.

3.  Assemble the outside air cover plate A supplied in com-

ponent pack.

4.  Re-install the access assembly. 

5.  Remove the outside air cover plate B on outer can and dis-

card.   

6.  Install  optional  flex  adapter  to  outer  can  with  the  same

screws. Do not use plastic wire ties that come with the kit as

they will melt. NOTE: You may need to install the flex pipe

into the firebox first depending on installation. Attach flex to

adapater with at least 2 screws.

7.  Ensure existing access hole in fireplace is sufficient to feed

the 4 inch flex.

8.  After sliding can into fireplace, feed flex into cut opening to

obtain outside combustion air.

9.  Level outer can and install appliance. See

1. Follow steps 1-5 in Option One above
2.  Ensure existing acces hole in fireplace will not be covered by

the outer can. Existing outside air intake hole may be under

at the rear or side of outer can. Outside air may also enter

down existing chimney chase in some situations.

3.  Repeat step 9 under Option One with one exception. After

installing the appliance in the outer can, seal the fireplace

opening and trim package with insulation to prevent air leak-

age into the room.

Outside air inlet must be located to prevent blockage from:

•  Leaves, snow, ice or other debris

Block may cause combustion air starvation
Smoke spillage may set off alarms or irritate sensitive indi-

viduals.

Grille hinges 

downward

Remove Screws & 

Pull Access Assembly 

away from Insert

Remove Outside Cover 

Plate A (Discard)

Outside Air Cover 

Plate B (Discard)

Termination 

Cap

Flex Adapter