Справочник Пользователя для Husqvarna 16 AWD

22 – 

English

1

Remove the frame plate by loosening the screws (2) and 
lift the frame plate by the rear edge.

2

Check the tension of the steering wires by squeezing 
them together by the arrows as illustrated. It should be 
possible to push them together so that the distance 
between them is half as much, without using unnecessary 
force.

3

If necessary, the wires can be adjusted by tightening the 
adjuster nuts on each side of the steering collar. Do not 
over tighten the cables; they should only be drawn in 
towards the steering collar.

Hold the cable, for example using an adjustable wrench, 
so that it does not twist.

If you only tension one side the steering wheel’s centre 
position may change.

Check the wire tension on completion of the adjustment 
as per item 2.

The brake is a disc brake and is located on the gearbox. 
Check that the brake is adjusted correctly by measuring the 
distance between the brake lever and front edge of the cut-out 
on the chassis.

The distance should be 0-1 mm (0-0.040') when the brake is 
not actuated.

1

Loosen the locking nuts (1).

2

Tension the cable with the adjuster screw (2) so that the 
distance between the brake lever and front edge of the 
cut-out on the chassis is 1 mm (0.040”).

3

Tighten the locking nuts (1) after adjustment.

Check that the brake is correctly adjusted by placing the 
machine on a slight downhill slope with the clutch disengaged 
and activating the brake.

When the machine does not stand still, the brake should be 
adjusted according to the following.

1

Loosen the locking nuts (1).

2

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

3

Tighten the locking nuts (1).

4

The brake should be checked again after adjustment