Справочник Пользователя для Nilfisk-Advance America C 125.3

9

The washer can take in water 
from a rain water tank as an 
example. The hose for the wa-
ter supply must not be too long, 
approx. 5 m.

Make sure that the water tank 
is not placed on a lower level 
than the machine.

1. Place the other end of the 

water hose in the water tank. 
Use an external fi lter if the 
water contains impurities.

2.  Turn the start/stop switch (1) 

to position"I".

3. Activate the trigger of the 

spray gun and let the water 
run, until the air has escaped 
from the water hose and the 
pump.

4. Mount spray lance and 

 nozzle.

The pressure can be regulated 
on the TORNADO

 PR nozzle.

Lavtryk 

Højtryk 

High pressure

Low pressure

Effi cient high presure cleaning is achieved by following a few guide-
lines, combined with your own personal experience of specifi c 
cleaning tasks. Accessories and detergents, when correctly cho-
sen, can increase the effi ciency of your pressure washer. Here is 
some basic information about cleaning.

Foam or detergent should be applied onto dry surfaces so that the 
chemical product is in direct contact with the dirt. Detergents are 
applied from bottom to top, for example on a car bodywork, in order 
to avoid "super clean" areas, where the detergent collects in higher 
concentration and streams downwards. Let the detergent work for 
several minutes before rinsing but never let it dry on the surface be-
ing cleaned. Note: It is important that the detergents do not dry up. 
Otherwise the surfac that has to be cleaned can be da maged.

In order to break down tough layers of dirt, additional mechanical 
effect may be required. Special wash brushes offer this supplemen-
tary effect that cuts through dirt (especially by car washing).