Справочник Пользователя для Mitsubishi Electronics MDS-R

 
 
 

 

 

7 - 13

 

GRZG400-2OHMJ 

 

100mm or more

P 

 

C

 

Wire length 5m or less 

Use a twisted flame retardant wire.

 

 

CN30 

External optional regenerative resistor

100mm or more 

Install a protective cover to prevent
foreign matter (cutting chips, cutting oil,
etc.) from entering the regenerative
resistor or the regenerative resistor from
being touched directly. 

 

 

 

1.  Install the regenerative resistor unit in the control panel or in the place in 

where foreign matter does not enter the regenerative resistor unit. If 
foreign matter (cutting chips, cutting oil, etc.) enters the regenerative 
resistor, the servo drive unit could be damaged or fires could be caused. 

2.   Always mount a protective cover so that the cables, etc., do not directly 

contact the regenerative resistor. A short-circuit across P-C could result in 
servo drive unit damage. 

3.   The regenerative resistor heats up to approx. 100 degrees. (It may get 

hotter depending on the installation conditions.) Pay special attention to 
heat dissipation and the installation position. 
Do not touch the regenerative resistor directly. 

4.   Use flame retardant wires or provide flame retardant treatment for the 

wires connected to the regenerative resistor. 

 

 

1.   When installing on a wall, install the regenerative resistors vertically. 
2.   The regenerative resistor generates heat and will reach high temperatures 

if the regeneration frequency is high. Do not install on wall surfaces 
susceptible to heat. 

3.   When installing three resistors in a row, leave a space of 100mm or more 

between each unit. 

4.  Always use twisted pair cables for connection with the servo drive unit, and 

keep the wire length 5m or less. Refer to section "5-1. Selecting the wire 
size" for details on selecting the wire.